Air compressor parts, compressor parts,filters,parts, air dryers Three Rivers Compressed Air Indiana

Compressed air is expensive to produce. Because compressed air is also clean, readily available, and simple to use, it is often chosen for applications in which other methods or sources of air are more economical. To reduce compressed air energy costs, alternative methods of supplying low-pressure end uses should be considered before using compressed air in such applications. Many alternative methods of supplying low-pressure end uses can allow a plant to achieve its production requirements effectively.

Before deciding to replace a low-pressure end use with an alternative source, it is important to determine the minimum practical pressure level required for the application.

Alternative Applications to Low-Pressure End Uses  

Existing Low-Pressure End UsePotential AlternativesReasoning
Open blowing, mixingFans, blower, mixers, nozzlesOpen-blowing applications waste compressed air. For existing open-blowing applications, high efficiency nozzles could be applied, or if high-pressure air isn’t needed, consider a blower or a fan. Mechanical methods of mixing typically use less energy than compressed air.
Personnel coolingFans, air conditioningUsing compressed air for personnel cooling is not only expen-sive, but can also be hazardous. Additional fans or an HVAC upgrade should be considered instead.
Parts cleaningBrushes, blowers, vacuum pumpsLow-pressure blowers, electric fans, brooms, and high-efficiency nozzles are more efficient for parts cleaning than using compressed air to accomplish such tasks.
Air motors and air pumpsElectric motors, mechanical pumpsThe tasks performed by air motors can usually be done more efficiently by an electric motor except in hazardous environ-ments. Similarly, mechanical pumps are more efficient than air-operated double diaphragm pumps. However, in an explosive atmosphere and/or the pumping of abrasive slurries, the application of a double diaphragm pump with appropriate pressure regulating and air shut-off controls may be appropriate.

Case Study: Low-Pressure End Uses are Replaced with Alternative Applications

A bottling plant was using compressed air in some applications that could be better supported with less energy-intensive methods. The plant was cooling and hardening bottlenecks by blowing cool, compressed air on them. Also, some of the blow mold machines were continuously blowing compressed air through air jets onto the pre-form feed lines to prevent them from jamming. Lastly, the plant’s stackers in the packaging area were using compressed air-operated venturi vacuum producers to pick up and position dividers between layers of bottles. To cool the bottlenecks, the application of a small blower that would blow cool air from chilled water was  recommended. The installation of an electromechanical vibrator was identified as the best way to prevent the feed lines from jamming. Finally, a central vacuum system having energy costs that were 30% lower than that of the venturi devices was shown to be as effective as the existing system. The annual compressed air energy savings from implementing these simple modifications was $80,000. 


Share or Bookmark this page...
Facebook LinkedIn